Display Settings

Watch this short tutorial video here: Display Settings.

Follow the steps below to use the Display Settings:  

1.  Find the Display Settings in the sidebar  

2. Display Settings options include Solid, Point, Mode, and Backface

3. Solid display mode is only available with Scan&Teleport camera type. Solid displays 3D scan data as a solid-surface mesh. 

4. The Point setting can be used in any camera type and displays 3D scan data as mesh vertices. 

5. Mode allows to toggle between various display modes: RGB, Intensity, X-Ray, Heightmap, Surface, and 2D Panoramic Display (Scan Mode Only).

6. RGB displays the 3D scan data in a form of a colorized mesh. Fallback on Surface display mode happens if no RGB information is found:

7. Intensity displays the 3D scan data and fallback on Surface display mode if no RGB information is found:

8. X-Ray displays the 3D scan data as see-through:

9. Heightmap displays the 3D scan data with height information:

10. Surface displays the 3D scan data with no color information:

11. 2D Panoramic (Scan Mode only) displays the panoramic image at each scan position:

12. The Backface setting allows to hide the backfaces of the 3D mesh surfaces: 

Backface setting enabled = hide backface surfaces

Backface setting disabled = show backface surfaces